Mercury 6L2Z-7B066-JA Plate - Clutch Pressure

You can Select Your Vehicle to check if 6L2Z-7B066-JA fits your vehicle.

The bolts should be turned a little at a time in a criss-cross pattern until all spring pressure is relieved, then the pressure plate can be removed.

Inspecting and replacing worn clutch components is recommended whenever the engine or transmission is removed unless they are new or in excellent condition. This ensures the clutch system's reliability and performance.

Reassemble by positioning the pressure plate on the flywheel and aligning the clutch disc with the flywheel using an alignment tool. Tighten the pressure plate-to-flywheel bolts evenly in a criss-cross pattern, centering the clutch disc with the alignment tool. Lubricate the release bearing and install it, along with the clutch release cylinder if removed earlier.

When removing clutch components, you should inspect the following components: Flywheel for defects Clutch disc for wear and damage Release bearing Release cylinder Pilot bearing Pressure plate surfaces If any of these components are found to be defective, they should be replaced to ensure the proper functioning of the clutch system.