Mercury F8ZZ-9C968-AA Regulator - Fuel Pressure

You can Select Your Vehicle to check if F8ZZ-9C968-AA fits your vehicle.

The first step in removing the air intake plenum and throttle body on a 5.0L engine involves disconnecting the negative battery cable. Also, unplug electrical connectors at the air bypass valve, throttle position sensor, and EGR position sensor. Disconnect the accelerator cable and transmission linkage from the throttle body assembly, remove the accelerator cable/TV cable bracket from the intake manifold, and label and detach vacuum lines from the upper intake manifold vacuum tree, EGR valve, and fuel pressure regulator. Make sure to disconnect the PCV system or any canister purge line if it is present and also downsize the water pipes of spacer coolant lines for EGR. Unbolt six (6) upper manifold retaining bolts to separate the upper manifold and throttle body as an assembly from the lower manifold. Ensure the gasket is in place during installation, attach new gasket(s) onto lower intake mounting face, and snug up air intake plenum with throttle body assembly by using six (6) upper manifold retaining bolts right up to the recommended torque value.

Continue by disconnecting the PCV system and, if present, the canister purge line and EGR spacer coolant lines, draining the coolant if needed. Remove the six upper intake manifold retaining bolts and lift off the upper intake manifold and throttle body as an assembly from the lower intake manifold.