Mercury F57Z-3530-A Shroud Assembly - Steering Column

You can Select Your Vehicle to check if F57Z-3530-A fits your vehicle.

For 2010 and earlier models, begin by removing the steering column cover screws, then take off the cover and opening reinforcement. If applicable, unscrew the tilt lever, squeezing the top and bottom of the tilt lever collar to remove it. Next, take out the screws from the underside of the lower column shroud and lower the shroud away from the column, moving the shift lever if the vehicle has an automatic transmission. Lift the upper shroud half off the column, and for installation, reverse the removal steps. For 2011 models, start by removing the key lock cylinder. If equipped, unscrew the tilt lever and remove it by squeezing the collar. Then, take out the cover mounting screws from below the steering column and remove both the upper and lower covers, with installation being the reverse of removal.

Disconnect the negative battery cable. Remove the key lock cylinder, which is only necessary for the removal of the upper column cover. Use a small wrench to remove the tilt wheel lever if equipped. Remove the screws from the lower steering column cover, then separate the steering column cover halves to detach them from the column. Finally, separate the cover halves and detach them from the steering column, with installation being the reverse of removal.

Disconnect the negative battery cable. Remove the key lock cylinder, which is only necessary for the removal of the upper column cover. Use a small wrench to remove the tilt wheel lever if equipped. Remove the screws from the lower steering column cover, then separate the steering column cover halves to detach them from the column. Finally, separate the cover halves and detach them from the steering column, with installation being the reverse of removal.

Remove the steering column cover screws and remove the cover and opening reinforcement.