Mercury 6S4Z-11V002-AARM Starter Motor Assembly

You can Select Your Vehicle to check if 6S4Z-11V002-AARM fits your vehicle.

Remove the wiring harness from the stud on the starter. Also remove the power steering bracket nut, then move the power steering tube and bracket aside.

The cost of repairs should be checked to determine if it is more economical to obtain a new or exchange starter.

The battery cables might overheat due to the large amount of current being drawn from the battery. Discontinue testing until the starting system has cooled down. If the starter motor cranking amp values are not within the correct range, replace it with a new unit. Ensure the battery is in good condition, the cold-cranking rating is adequate, and that the battery terminals and cables are clean and not corroded. In extreme cold temperatures, warm the battery or engine block before performing tests.

No, it's not necessary, but detaching the center bearing support bracket will provide enough room to remove the starter.

Remove the two bolts and then lower the starter motor from the front of the engine compartment.

Do not immediately assume that the starter is causing the problem. First, check the following items: a) Make sure that the battery cable clamps are clean and tight where they connect to the battery. b) Check the condition of the battery cables and replace any defective ones with new parts. c) Test the condition of the battery; if it does not pass all tests, replace it with a new battery. d) Check the starter solenoid wiring and connections. e) Check the starter mounting bolts for tightness. f) Ensure that the shift lever is in PARK or NEUTRAL (for automatic transaxle) or that the clutch pedal is pressed (for manual transaxle). g) Check the adjustment of the Transmission Range (TR) sensor on vehicles with an automatic transaxle. For manual transaxle vehicles, ensure that the Clutch Pedal Position (CPP) switch is correctly installed. h) Check the operation of the starter relay located in the engine compartment fuse and relay box.