Warranty: This genuine part is guaranteed by Ford's
factory warranty.
Fits the following Vehicles:
2007-2011 Ford Crown Victoria | 8 Cyl 4.6L Romeo SOHC EFI | 4-Speed Automatic Transmission 4R75E Livonia, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
Q: How to remove and install the control assembly on Ford Crown Victoria?
A: The following procedure requires the removal of several interior trim parts. Remove the left side and right side instrument panel molding assemblies. Remove the cluster trim panel screws. Remove the knob from the headlamp switch and remove the headlamp switch shaft. Remove the lower insulator/knee protector panel. Remove the steering column upper and lower covers. Remove the screws retaining the steering column trim panel reinforcement bracket and remove the bracket. Position the wheels in the straight ahead position. Remove the nuts retaining the steering column. Lower the steering column and remove the PRNDL cable. Let the steering column rest on the front seat. Remove the instrument cluster bezel and the center bezel. Disconnect the electrical connectors to any of the accessory switches. Remove four cap screws from the A/C Switch. After the trim is removed, remove the four screws and pull the control assembly out of the dash. Pull the control out of the instrument panel. The vacuum lines are clustered together, and removed as a single connection. The vacuum lines and electrical switch can be disconnected after the control has been removed from the dash. Installation is the reverse of the removal procedure.