Q: How do I remove and install the front stabilizer bar, Bushing and links on Ford Mustang?
A: Raise and secure the vehicle on jack stands and discard sway bar-to-link nuts while holding the ball stud with a wrench. To remove the link, remove strut-to-link nuts. Detach the sway bar kit from the vehicle by removing the bracket nuts. Inspect and discard damaged bushings. Lubricate and install new bushings onto the bar kit. Install sway bar links with new nuts. Finally, tighten all nuts to the specified torque.
Q: How to remove and install the rear stabilizer bar, Bushing and links on Ford Mustang?
A: The manufacturer advises using new fasteners for Sway Bar Kit and links installation. Note that replacement bushings and sway bars differ for coupes and convertibles. Ensure the correct part for your vehicle. Start by raising the vehicle's rear and supporting it on jackstands under the frame. Remove and discard the link-to-chassis fasteners. Detach the sway bar kit brackets from the rear axle brackets and remove the bar. Inspect the bushings for damage and replace if necessary. Lubricate new bushings with silicone spray and attach them to the bar. Reinstall in reverse order, tightening all fasteners to the specified torque. Finally, remove the jackstands and lower the vehicle.