Ford 6W1Z-3085-M Arm Assembly - Front Suspension

You can Select Your Vehicle to check if 6W1Z-3085-M fits your vehicle.

Begin by loosening the wheel lug nuts. Raise the front of the vehicle and securely support it with jackstands. Remove the front wheel.

Remove the cotter pin from the upper balljoint stud and loosen the stud nut slightly. Place a floor jack under the lower control arm and raise it slightly. Tap the steering knuckle near the upper balljoint stud with a hammer to loosen it. Use a balljoint stud separator if needed (note that this may damage the balljoint boot). Remove the nut from the upper balljoint stud and the upper control arm pivot shaft attaching bolts. Remove the upper control arm and pivot shaft as an assembly.

Remove the shock absorber (for 2002 and earlier models). On 1988 through 1991 models, disconnect the stabilizer bar link from the lower control arm. Remove the coil spring (for 2002 and earlier models).

Position the upper control arm pivot shaft on the frame. Install the attaching bolts and washers. Insert the upper balljoint stud into the steering knuckle and secure it with the nut or pinch bolt.