Ford 6W1Z-4264-B Bar - Rear Stabilizer

You can Select Your Vehicle to check if 6W1Z-4264-B fits your vehicle.

Raise the rear of the vehicle and support it securely on jackstands, placing the jackstands under the frame, not under the axle housing. The axle housing must be free to hang down so that the shock absorbers are fully extended. On 1988 through 1991 models, remove the four Sway Bar Kit-to-lower suspension arm bolts and remove the bar. On 1992 and later models, remove the nuts that attach the Sway Bar Kit ends to their links, then remove the other link nut. Also on 1992 and later models, remove the bushing clamp bolts that attach the Sway Bar Kit to the axle housing, then remove the other clamp bolt. Installation is the reverse of the removal procedure. On 1988 through 1991 models, be sure to install the bar with the paint mark on the right hand side of the vehicle. On all models, be sure to tighten all fasteners to the torque values. Before attempting to drive a vehicle equipped with air suspension, turn the air suspension switch to On, start the engine and allow the compressor to inflate the air suspension springs, which deflate automatically when the rear of the vehicle is raised.

Remove the nuts that attach the bushing clamps to the frame.

On 1988 through 1991 models, the four stabilizer bar-to-lower suspension arm bolts should be removed and the bar should be removed.

Remove the nut from each end of the stabilizer bar.