Ford 6R3Z-6343262-A Cylinder Assembly - Lock

You can Select Your Vehicle to check if 6R3Z-6343262-A fits your vehicle.

To replace the trunk lid latch, firstly open the trunk and then gently apply a force to the latch trim cover in order to remove the mounting clips. It is recommended that a line be drawn around the trunk lid latch assembly for alignment during a repair. Disconnect the electrical connectors and the trunk lock actuator from the lock cylinder then un-bolt the retaining nuts and pull the latch off. For models up to 2010, go to the trunk to complete the following; pull the latch trim cover off in the following manner; Detach any electrical connectors and trunk lock actuator to the lock cylinder: you must detach the actuator before the removal of the mounting fasteners. After that, the lock cylinder mounting fasteners should be withdrawn and the lock cylinder should be taken out from the vehicle. Installation process is, however, the reverse of the removal process. Please remember that for the 2011+ cars, the trunk lock cylinder has been replaced by the trunk lid release switch which should be ordered with the latch assembly only.

In order to replace the key lock cylinder, to put the new rivets in the door one needs a special rivet installation tool. Start with the pull-down strap fasteners and the strap and then pry the pin type fasteners with a plastic trim tool and then pull out the trunk lid trim panel. Finally, some irregularities may occur when the trunk lid actuator cable is removed from the key lock cylinder, and the electrical connector disconnected from the lock cylinder is removed. Two rivets are to be drilled out separating the lock cylinder and it should be pulled out. For reinstallctions, removal should be done in the reverse order that they were done in. For the latch start with the removal of the trim panel and then you will have to unplug the electrical connectors of the trunk lid latch. After that, it is necessary to remove the latch mounting nuts and then the latch itself is to be removed. As mentioned earlier, reinstallation has to be done from right from the bottom and has to progress upwards in a sequential manner, that is, a process that is almost similar to that of removal in reverse.

Raise the window, then remove the door trim panel and watershield.

Remove the trim cap for the outside handle retaining screw and loosen, but don't remove, the screw.

NO, KIT IS MADE TO BE BUILT AROUND AN EXISTING KEY.