Ford F6TZ-7A098-BB Filter Assembly

You can Select Your Vehicle to check if F6TZ-7A098-BB fits your vehicle.

At specified intervals, change transmission fluid and replace filter. No drain plug, remove transmission oil pan to drain fluid. Warm up vehicle, support on jackstands. Place drain pan under pan, remove bolts, lower pan to drain fluid. Inspect for metal particles. Remove filter/strainer, clean surfaces, replace with new gasket. Apply RTV sealant, position new gasket, reinstall pan, tighten bolts diagonally. Lower vehicle, add fluid gradually through dipstick tube, check level with dipstick, run engine through gears. Drive to reach normal temperature, park on level surface, check fluid level again, adjust as needed. Avoid overfilling.

Ensure the gasket surface on the transmission pan is clean, and then install a new gasket. Put the pan in place against the transmission and install the bolts. When tightening the bolts, work around the pan, and tighten each bolt a little at a time. Be cautious not to overtighten the bolts.

Clean the gasket surface of the transmission to remove all remnants of the old gasket and sealant. Drain the fluid from the transmission pan, clean it with solvent, and thoroughly dry it. Upon initial service, you may find a plastic plug in the bottom of the pan, which was used to keep contamination out during assembly. Discard this plug. Remove the old filter from the transmission. If the filter seal didn't come out with the filter, remove it carefully without damaging the seal bore. Install a new seal and filter.

Remove the torque converter cover, drain the fluid from the torque converter, install a new drain plug, and lower the vehicle.

After reinstalling the transmission oil pan, lower the vehicle and gradually add transmission fluid through the dipstick tube.

NO, PART SOLD SEPARATQ