Ford F6TZ-6068-B Engine Support Insulator Assembly

You can Select Your Vehicle to check if F6TZ-6068-B fits your vehicle.

During the check, the engine must be raised slightly to remove the weight from the mounts.

For all other models, remove the mount-to-cross-member nuts and mount-to-transmission bolts. Place a jack under the transmission and raise it enough to remove the mount. Install a new mount and lower the transmission enough to start all fasteners hand tight. Remove the jack and tighten the mount fasteners to the specified torque. Remove the jackstands and lower the vehicle.

Engine mounts seldom require attention, but broken or deteriorated mounts should be replaced immediately to prevent damage to driveline components.

For early 4WO models, remove the lower insulator retainers and insulators, then remove the insulator bolts. Place a jack under the transmission and raise it enough to remove the upper insulators between the transmission bracket and crossmember. Install new upper insulators with the protruding shoulder facing down through the crossmember. Lower the transmission and install the insulator bolts, tightening the lower insulator retainer assemblies to the specified torque. Remove the jackstands and lower the vehicle, then test drive to confirm proper operation.