Make sure this part fits

Ford YL8Z-3B413-CA Joint And Stub Shaft Assy

2001-2006 Ford YL8Z3B413CA

Customer Questions & Expert Answers (3)
Ford YL8Z-3B413-CA Joint And Stub Shaft Assy
  • Part Description
    Joint And Stub Shaft Assy
  • Base No.
    3B413
  • Position
    Passenger Side
  • Manufacturer
    Ford
  • Manufacturer's Notes
    This part is discontinued.
Make sure this part fits
  • Related Parts
  • Product Specifications
  • Vehicle Fitment
  • Customer Questions & Expert Answers
  • Product Specifications

    BrandGenuine Ford
    Base No.3B413
    Manufacturer Part NumberYL8Z-3B413-CA, YL8Z3B413CA
    Part DescriptionJoint And Stub Shaft Assy
    Other NamesOuter CV Joint, Outer Joint Assembly
    Manufacturer NoteOuter
    Item Dimensions4.6 x 4.5 x 24.2 inches
    Item Weight9.30 Pounds
    PositionPassenger Side
    ConditionNew
    Fitment TypeDirect Replacement
    ManufacturerFord
    SKUYL8Z-3B413-CA
    WarrantyThis genuine Ford part is guaranteed by Ford's factory warranty.
    Shipping & ReturnShipping Policy Return Policy
    Warning: California’s Proposition 65
  • Vehicle Fitment

    Year Make Model Engine Important vehicle option details
    2001-2006 Ford Escape4 Cyl 2.0L Zetec EFI, 6 Cyl 3.0L DOHC EFI Modular4AT CD4E, Four-Wheel Drive (Full Time) (Left Hand Drive), Left Hand Drive, Two-Wheel Drive (Left Hand Drive)
    2005-2006 Mercury Mariner6 Cyl 3.0L DOHC EFI Modular4AT CD4E, Four-Wheel Drive (Full Time) (Left Hand Drive), Left Hand Drive, Two-Wheel Drive (Left Hand Drive)
  • Customer Questions & Expert Answers

    Q:
    Will these fit my car and if not which part will? Thank you. Posted by FordPartsGiant Specialist
    A:
    You can Select Your Vehicle to check if YL8Z-3B413-CA fits your vehicle.
    Posted by FordPartsGiant Specialist
    Q:
    What are the steps to install the rear driveaxle in the 2008 Ford Escape? Posted by Customer
    A:
    To install the rear driveaxle in 2004 and earlier models, follow these steps: a) Pry the old spring clip from the inner end of the driveaxle and install a new one. b) Apply a light film of grease to the area on the inner CV joint stub shaft where the seal rides, then insert the splined end of the inner CV joint into the differential. c) Make sure the spring clip locks in its groove. d) Apply a light film of grease to the outer CV joint splines, pry the trailing arm outward, and insert the outer end of the driveaxle into the hub. e) Install the coil spring. f) Connect the trailing arm to the lower suspension arm and install the nut. g) Using a floor jack, raise the trailing arm to simulate normal ride height and then tighten the nut. h) Install a new driveaxle/hub nut and tighten it before lowering the vehicle to prevent wheel bearing damage. i) Install the wheel and lug nuts, then lower the vehicle and tighten the lug nuts. j) Block the front wheels to keep the vehicle from rolling. k) Loosen the rear wheel lug nuts, raise the vehicle on jackstands, then remove the wheel. l) Remove the rear wheel driveaxle hub nut and discard it. m) Remove the coil spring. n) Remove the wheel speed sensor wiring harness mounting bolt. o) Remove the four bolts from the stabilizer bar bracket and discard them. p) Place a floor jack under the knuckle and support it. q) Remove the bolt from the lower ball joint, then separate the ball joint from the knuckle. r) Separate the inner and outer ends of the driveaxle from the differential and the hub. Work carefully to avoid damaging the CV joints and boots. s) Installation is the reverse of removal.
    Posted by FordPartsGiant Specialist
    See expert answers on similar Axle Shaft
    Q:
    How do you remove the front driveaxle in 2005 Mercury Mariner with a manual transaxle? Posted by Customer
    A:
    To remove the front driveaxle, follow these steps:a) Loosen the wheel lug nuts and raise the vehicle on jackstands.b) Remove the wheel and the driveaxle/hub nut from the axle, then separate the lower control arm from the steering knuckle.c) Swing the knuckle/hub assembly out until the end of the driveaxle is free of the hub. If the driveaxle splines stick in the hub, tap on the end of the driveaxle with a plastic hammer.d) Support the outer end of the driveaxle with a piece of wire to avoid unnecessary strain on the inner CV joint.e) If removing the right driveaxle, carefully pry the inner CV joint off the intermediate shaft using a large screwdriver or prybar. If removing the left driveaxle, pry the inner CV joint out of the transaxle using a large screwdriver or prybar, being careful not to damage the differential seal.f) Support the CV joints and carefully remove the driveaxle from the vehicle.
    Posted by FordPartsGiant Specialist
    See expert answers on similar Axle Shaft
    If you have any questions about this product, please don't hesitate to ask us. We will be happy to help you!

Genuine Ford Part YL8Z-3B413-CA, the Right Choice

Your vehicle deserves only genuine OEM Ford parts and accessories. To ensure reliability, purchase Ford part # YL8Z-3B413-CA Joint And Stub Shaft Assy with base parts number 3B413. It is sometimes referred to as Ford Axle Shaft. Our Ford parts and accessories are expedited directly from authorized Ford dealers strategically located all across the U.S. and are backed by the manufacturer's 12 month, 12,000 mile warranty. OEM Ford parts are the best for restoring your vehicle to factory condition performance. This part fits specific Ford Escape models. It fits Mercury Mariner.

Affordable, reliable and built to last, Ford part # YL8Z3B413CA Joint And Stub Shaft Assy stands out as the smart option. FordPartsGiant.com is your prime online source with the biggest and best selection of genuine Ford parts and accessories at giant discounted prices. We have the OEM Ford parts and accessories you need at the wholesale prices. FordPartsGiant.com has you covered no matter what type of Ford vehicle you drive. For detailed Ford parts information, click here.

Why choose Ford Parts Giant

  • Dedicated Service

    Your complete satisfaction is our #1 goal

  • Lowest Prices

    Best deals on genuine OE parts from dealerships

  • Fast Delivery

    Orders are processed and delivered promptly