Ford 6L5Z-18124-A Kit - Shock Absorber

You can Select Your Vehicle to check if 6L5Z-18124-A fits your vehicle.

Replace the shock absorbers as a set.

Remove the front disc brake water shield (if necessary).

Park the vehicle on level ground, turn the engine off, and set the parking brake. Check the tire pressures. Push down at one corner of the vehicle, then release it while noting the movement of the body. It should stop moving and come to rest in a level position with one or two bounces. If the vehicle continues to move up and down or fails to return to its original position, a worn or weak shock absorber is probably the reason. Repeat the check at each of the three remaining corners of the vehicle. Raise the vehicle and support it on jackstands. Check the shock absorbers for evidence of fluid leakage. Make sure any fluid noted is from the shocks and not from any other source. If leakage is noted, replace the shocks as a set. Check the shock absorbers to be sure they are securely mounted and undamaged. Check the upper mounts for damage and wear. If damage or wear is noted, replace the shock absorbers as a set.

The low-pressure gas shock absorbers are pressurized to 135 PSI with nitrogen gas. Do not attempt to open, puncture, or apply heat to the shock absorbers.

Remove the nut and bolt securing the lower end of the shock absorber to the spring plate.

Yes, you should remove the front disc brake water shield if necessary (refer to Chapter 9 for details).

Remove the nut and bolt securing the lower end of the shock absorber to the spring plate (Remove the shock absorber lower bolt and nut).