Ford 7S4Z-18124-A Kit - Shock Absorber

You can Select Your Vehicle to check if 7S4Z-18124-A fits your vehicle.

If the original spring is to be reused, it can be left in compression. If a new spring is to be installed, the original spring must be carefully released from the compressor.

The manufacturer advises that all suspension and steering system fasteners that require a specific torque should be replaced with new ones whenever they have been removed. This does not apply to the subframe bolts.

Inspect for fluid leakage.

5. Chock the front wheels, jack up the rear of the vehicle, and support it on axle stands. Remove the wheels as required. 6. On the left-hand shock absorber, release the exhaust from the rubber hanger, then undo the rear exhaust muffler heat shield bolts and remove it to access the upper shock mounting nut. 7. Place a jack under the lower suspension arm/coil spring for support. Unscrew and remove the upper mounting bolt, then the lower mounting bolt. Withdraw the shock absorber from under the vehicle.