Ford XW1Z-18124-AA Kit - Shock Absorber

You can Select Your Vehicle to check if XW1Z-18124-AA fits your vehicle.

After installing the upper mount, the strut assembly should be guided into position in the wheel well by pushing the upper mount studs through the holes in the shock tower.

On models with air suspension, turn off the air suspension switch and disconnect the height sensor connector link before allowing the rear suspension to hang past its normal point of full rebound. Raise the rear of the vehicle and support it securely on jackstands. If the vehicle is a pre-1992 model with automatic leveling rear suspension and coil springs, allow the rear axle to hang free until the shock absorbers are finished venting through the compressor. Support the rear axle with a floor jack to prevent it from dropping when the shock absorber is disconnected. If removing an air-assisted shock absorber, detach the air line.

Clean the lower end of the steering knuckle and have an assistant move the wheel in and out while checking for movement at the steering knuckle-to-control arm balljoint.

All fasteners should be tightened to the specified torque.