Ford 5L8Z-5G232-EA Exhaust Manifold Assembly

You can Select Your Vehicle to check if 5L8Z-5G232-EA fits your vehicle.

a) Connect a vacuum gauge to an intake manifold vacuum source. b) Warm the engine to operating temperature, place the transaxle in Park (automatic models) or Neutral (manual models), and apply the parking brake. c) Note the vacuum reading at idle and jot it down. d) Quickly open the throttle to near its wide-open position and then quickly get off the throttle and allow it to close. Note the vacuum reading and jot it down. e) Repeat this test three more times, recording your measurement after each test. f) If your fourth reading is more than one in-Hg lower than the reading noted at idle, the exhaust system might be restricted, indicating that the catalytic converter could be plugged, or an exhaust pipe or muffler could be restricted.

Run the engine and check for exhaust leaks.

A catalytic converter (or catalyst) is an emission control device in the exhaust system that reduces certain pollutants in the exhaust gas stream. There are two types of converters: an oxidation catalyst, which reduces hydrocarbons (HC) and carbon monoxide (CO), and a reduction catalyst, which reduces oxides of nitrogen (NOx). Catalysts that can reduce all three pollutants are known as "three-way catalysts." The models covered by this manual are equipped with three-way catalysts.

The remainder of the installation is the reverse of removal.

Unplug the electrical connector for the oxygen sensor and then remove the oxygen sensor from the exhaust manifold.

Remove the passenger's side inner fender splash shield and the engine drive belt.