Make sure this part fits

Ford F2VY-17V508-ARM Motor Assembly - Wiper

1990-1994 Ford F2VY17V508ARM

Customer Questions & Expert Answers (4)
Ford F2VY-17V508-ARM Motor Assembly - Wiper
  • Part Description
    Motor Assy - Wiper
  • Replaced By
    F2VY-17V508-AARM
  • Manufacturer
    Ford
  • Manufacturer's Notes
    This part is discontinued.
Make sure this part fits
  • Related Parts
  • Product Specifications
  • Vehicle Fitment
  • Customer Questions & Expert Answers
  • Product Specifications

    BrandGenuine Ford
    Manufacturer Part NumberF2VY-17V508-ARM, F2VY17V508ARM
    Part DescriptionMotor Assy - Wiper
    Manufacturer NoteReman wiper motor, (may require FOVY-17V436-ARM output arm, 1W7Z-17V485-AARM bracket and F5AZ-17C518-AA windlatch assembly)
    Item Dimensions11.3 x 11.3 x 9.3 inches
    Item Weight5.30 Pounds
    ConditionNew
    Fitment TypeDirect Replacement
    ManufacturerFord
    SKUF2VY-17V508-ARM
    WarrantyThis genuine Ford part is guaranteed by Ford's factory warranty.
    Shipping & ReturnShipping Policy Return Policy
    Warning: California’s Proposition 65
  • Vehicle Fitment

    Year Make Model Engine Important vehicle option details
    1992-1994 Ford Crown Victoria8 Cyl 4.6L4AT AOD, 4AT AOD-E
    1990-1994 Lincoln Town Car8 Cyl 4.6L, 8 Cyl 5.0L4AT, 4AT 4R70W, 4AT AOD, 4AT AODE
    1992-1994 Mercury Grand Marquis8 Cyl 4.6L4AT, 4AT AOD, 4AT AODE
  • Customer Questions & Expert Answers

    Q:
    Is the the correct part for the attached VIN? Posted by FordPartsGiant Specialist
    A:
    You can Select Your Vehicle to check if F2VY-17V508-ARM fits your vehicle.
    Posted by FordPartsGiant Specialist
    Q:
    How to remove and install a wiper motor in a Lincoln Town Car? Posted by Customer
    A:
    Detach the cable from the negative battery terminal. In 1979 and earlier models, unfasten wiper arms on pivot shafts. For left (driver) side cowl screen removal to reach motor drive arm linkage. Take off retaining clip and disconnect drive arm from wiper linkage. Separate electrical connectors, unbolt it and slide out of position. Swivel it while pulling up so the firewall opening will not obstruct wiper drive arm. Once you are satisfied that the wiper motor drive arm is in its parked position, do the reverse of taking out for installation purpose. On 1980 and later models, remove the rear hood seal as well as the cover for wiper motor housing. Remove components after removing rear hood seal weatherstripping by taking a screwdriver under each of them on both sides of wiper housing. Cowl covers must be removed first with models manufactured in 1998 and beyond. Wiper motor retaining bolts must be removed. Should also remove clip from motor to disconnect wipper linkange driver arm from motor's hole too.Wiggle a small screwdriver into the back part of this clip; this causes it to fall off allowing detachment of arm from engine.Pull out connector coming out of an electrical battery; now raise two other points at which you can get hold of axle connected to pulley surrounding rotationally mountable wiping device.Unit is returned or replaced as previously done during detaching; something like this is then reversed upon being fixed again.Also, take out that rear hood seal then break that cover for housing fitted over such a device mounted there.Remove those parts which should only involve getting rid of strips running along respective rails situated outside casing around entire rubber sealing material.Simply start by removing cowling covers just like when talking about cars' bonnets.This is why we have made sure that our car has been reasonably parked before attempting anything because doing so would put us at risk of getting into an accident.Installation is the opposite of removal.
    Posted by FordPartsGiant Specialist
    Q:
    How is the installation process described for the 1990 Mercury Grand Marquis? Posted by Customer
    A:
    Installation is the reverse of removal.
    Posted by FordPartsGiant Specialist
    See expert answers on similar Wiper Motor
    Q:
    How do you disconnect the wiper linkage drive arm from the motor for the 1992 Ford Crown Victoria? Posted by Customer
    A:
    Use a small screwdriver to pry off the clip, then detach the wiper arm from the motor.
    Posted by FordPartsGiant Specialist
    See expert answers on similar Wiper Motor
    If you have any questions about this product, please don't hesitate to ask us. We will be happy to help you!

Genuine Ford Part F2VY-17V508-ARM, the Right Choice

To ensure reliability, purchase Ford part # F2VY-17V508-ARM Motor Assembly - Wiper. It is sometimes referred to as Ford Wiper Motor. In terms of quality and longevity, OEM parts are top-tier. This is because they are made according to Ford's demanding factory specifications and go through strict quality control. This part fits specific Ford Crown Victoria models. It fits Lincoln Town Car. It also fits Mercury Grand Marquis.

FordPartsGiant.com is a leading supplier of genuine Ford parts and accessories such as Ford F2VY17V508ARM Motor Assembly - Wiper. On our platform, we provide genuine Ford parts at incredible prices while ensuring top-tier quality. Feel at ease shopping with us, knowing our parts have a hassle-free return policy and rapid delivery service. For detailed Ford parts information, click here.

Why choose Ford Parts Giant

  • Dedicated Service

    Your complete satisfaction is our #1 goal

  • Lowest Prices

    Best deals on genuine OE parts from dealerships

  • Fast Delivery

    Orders are processed and delivered promptly