Ford YC2Z-8501-BA Pump Assembly - Water

You can Select Your Vehicle to check if YC2Z-8501-BA fits your vehicle.

Disconnect the cable from the negative battery terminal. With the engine cold, drain the cooling system. Remove the fan shroud and the fan assembly. Remove the drivebelt(s) and remove the water pump pulley. On V6 engines, disconnect the upper radiator hose from the water pump and remove the bolt and detach the heater water outlet tube from the top of the pump. Remove the water pump retaining bolts and remove the water pump. Take note of the installed positions of the various length bolts and studs. Before installation, remove and clean all gasket or sealant material from the water pump and cylinder block. If you're working on a VB engine, inspect the O-ring and sealing surface of water pump housing in the block for dirt or debris. Clean them thoroughly before reassembly. If you're working on a VB engine, lubricate a new O-ring seal with clean antifreeze and install it to the water pump. If you're working on a V6 engine, coat a new gasket with a thin film of RTV sealant and install it on the pump. Install the water pump and tighten the bolts to the specified torque. The remainder of the installation is the reverse of the disassembly sequence. Fill the cooling system with the proper coolant mixture. Start the engine and make sure there are no leaks. Check the level frequently during the first few weeks of operation to ensure there are no leaks and that the level in the system is stable.

Remove the drivebelt(s) and the water pump pulley.

Fill the cooling system with the correct coolant mixture, start the engine, check for leaks, and monitor the coolant level during the initial weeks of operation.

If any one of these quick checks indicates water pump problems, it should be replaced immediately.

If the water pump fails, it can lead to engine overheating and serious damage.

If the water pump fails, it can lead to engine overheating and serious damage.