Ford 9L8Z-3A329-D Shaft

You can Select Your Vehicle to check if 9L8Z-3A329-D fits your vehicle.

To remove the intermediate shaft, follow these steps: a) Remove the right side wheel cover or hub cap and break the hub nut loose with a socket and large breaker bar. b) Loosen the wheel lug nuts and raise the vehicle on jackstands. c) Remove the wheel and the driveaxle/hub nut from the axle. d) Swing the knuckle/hub assembly out until the end of the driveaxle is free of the hub. If the driveaxle splines stick in the hub, tap on the end of the driveaxle with a plastic hammer. e) Support the outer end of the driveaxle with a piece of wire to avoid unnecessary strain on the inner CV joint. f) Remove the driveaxle. g) Remove the bearing support nuts and slide the intermediate shaft out of the transaxle. Be careful not to damage the differential seal when pulling the shaft out. h) Check the support bearing for smooth operation by turning the shaft while holding the bearing. If there is any roughness, have a new bearing installed at an automotive machine shop or qualified repair facility.

To remove the front driveaxle, follow these steps:a) Loosen the wheel lug nuts and raise the vehicle on jackstands.b) Remove the wheel and the driveaxle/hub nut from the axle, then separate the lower control arm from the steering knuckle.c) Swing the knuckle/hub assembly out until the end of the driveaxle is free of the hub. If the driveaxle splines stick in the hub, tap on the end of the driveaxle with a plastic hammer.d) Support the outer end of the driveaxle with a piece of wire to avoid unnecessary strain on the inner CV joint.e) If removing the right driveaxle, carefully pry the inner CV joint off the intermediate shaft using a large screwdriver or prybar. If removing the left driveaxle, pry the inner CV joint out of the transaxle using a large screwdriver or prybar, being careful not to damage the differential seal.f) Support the CV joints and carefully remove the driveaxle from the vehicle.