Ford K2GZ-18124-Q Shock Absorber Assembly

You can Select Your Vehicle to check if K2GZ-18124-Q fits your vehicle.

1. Guide the assembly up into the fenderwell. 2. Align the previously made match marks. 3. Insert the upper mounting studs through the holes in the body. 4. Once the studs protrude, install the new nuts to prevent the shock from falling back through, but don't tighten them yet. 5. Use the jack to position the steering knuckle. 6. Install the two lower mounting bolts and nuts. 7. Tighten the nuts to the specified torque. 8. Install the wheel and lug nuts. 9. Lower the vehicle and tighten the lug nuts to the specified torque. 10. Finally, tighten the upper mounting nuts to the specified torque.

Loosen the wheel lug nuts, raise the vehicle and support it securely on jackstands. Block the front wheels to prevent the vehicle from rolling and remove the rear wheel.

To maintain balanced characteristics on both sides of the vehicle, it's advisable to replace components on both sides simultaneously.

Ensure the vehicle is parked on level ground with the engine off and the parking brake engaged while verifying tire pressures.