Ford 4L3Z-18124-HA Shock Absorber Assembly

You can Select Your Vehicle to check if 4L3Z-18124-HA fits your vehicle.

To remove the shock absorber block the front wheels and place a jack under the axle near the shock absorber, lifting slightly. Remove the nut and bolt from the lower end of the shock absorber, then the upper end. Reverse these steps to install the new shock absorber.

Regularly inspecting driveaxle boots, especially the outer CV boot, on 4WD models is crucial because these boots protect the CV (constant velocity) joints from dirt and damage. If the boots are torn, cracked, or have loose clamps, they can allow dirt and contaminants to enter the CV joint, leading to premature wear and potential joint failure. Cleaning the boots with soap and water helps prevent oil and grease from deteriorating them, ensuring the CV joints remain protected and functional. If any evidence of damage or lubricant leakage is found, prompt replacement of the boots is necessary to maintain the integrity of the CV joints.

Inspect the shock absorber, coil spring, and spring seats for any damage or wear. If necessary, have the unit serviced by a qualified repair shop or replace it.