Ford F75Z-5560-FA Spring - Coil

You can Select Your Vehicle to check if F75Z-5560-FA fits your vehicle.

For coil spring, Loosen rear wheel lug nuts, raise rear of vehicle and support securely on jackstands. Remove rear wheels. Remove driveshaft. Unplug rear ABS speed sensor connector. Release parking brake system and disconnect cables. Remove calipers and hang safely. Detach axle vent tube and rear stabilizer bar. Support rear axle with floor jack. Disconnect shock absorbers, track bar, and suspension arms from axle. Lower axle and remove coil springs. Installation is reverse of removal. Don't tighten suspension fasteners until vehicle is on ground.For air spring: Turn off air suspension system. Loosen rear wheel lug nuts, raise rear of vehicle and support securely on jackstands. Remove rear wheels. Remove air spring retainer. Lift bottom of air spring off axle. Unplug air spring solenoid connector. Disconnect air line and remove air spring. Installation is reverse of removal. Ensure 1/8 inch of white air line is inserted into solenoid. Reactivate air suspension system, start engine, and allow compressor to pump up system to normal trim height.

The coil spring and lower control arm should be installed.

Yes, it is possible to replace shocks or springs individually. However, disassembling the unit will require the expertise of a qualified repair shop with the proper equipment, which can add considerable cost to the project. You should compare the cost of replacing the complete assemblies yourself to the cost of replacing individual components with the assistance of a shop.