Ford G2MZ-11002-AZ Starter Motor Assembly

You can Select Your Vehicle to check if G2MZ-11002-AZ fits your vehicle.

Before assuming the starter is the problem, the following items should be checked in the starting circuit:1. Ensure that the battery cable clamps are clean and tightly connected to the battery.2. Inspect the condition of the battery cables and replace any damaged ones.3. Test the battery to determine if it needs to be replaced.4. Check the tightness of the starter mounting bolts.5. Verify the adjustment of the Digital Transmission Range sensor or Clutch Pedal Position switch and ensure that the shift lever is in the correct position.6. Check the operation of the starter relay, which is located in the engine compartment fuse and relay box on later models.

Be cautious as the battery cables may become excessively heated due to the large amount of amperage being drawn. Discontinue testing until the starting system has cooled down.

Raise the vehicle and support it securely on jackstands.

Tighten the starter bolts to the specified torque.

Abnormally slow starter motor cranking may be attributed to factors like a partially seized engine, incorrect oil viscosity, or issues with the battery and terminal connections.

Remove the protective cover from the B+ terminal, then remove the nut and disconnect the battery cable from the B+ terminal on the solenoid. After that, remove the other nut and disconnect the starter cable from the S terminal on the solenoid.