Lincoln YU5Z-13466-AD Bulb

You can Select Your Vehicle to check if YU5Z-13466-AD fits your vehicle.

Installation is the reverse of removal.

Always check the bulb contacts and holder to ensure there is clean metal-to-metal contact. Clean off any corrosion or dirt before installing a new bulb.

Rotate the bulb holder counterclockwise and pull out the bulb and holder assembly. The bulb cannot be removed from the holder, so pull it out of the headlight housing as a complete assembly.

1. The fog lights are located in the lower part of the bumper cover. Use a creeper or an old blanket to lie on, and take a flashlight with you. 2. To remove the fog light bulb socket from the fog light housing, turn it counterclockwise and pull it out. 3. Disconnect the electrical connector from the fog light bulb. 4. Reconnect the electrical connector to the new fog light bulb. 5. To install the fog light socket in the fog light housing, insert it into its mounting hole and turn it clockwise until it stops.

Carefully pry the sidemarker light housing out of the rear bumper cover.

Pull the bulb socket out of the headlight assembly.

Carefully pull the bulb straight out of the socket without rotating it.

Disconnect the cable from the negative battery terminal.

Make sure that the headlight switch and the ignition switch are both turned off, then open the hood.

Remove the assembly by taking out the mounting screws and washers, disconnect the electrical connector, and place the assembly on a workbench. Separate the bulb holder assembly from the lens and replace the bulb by pulling it straight out and pushing the new one in. Reassemble and use new mounting screws and washers if recommended by the manufacturer.

Pry the cargo light assembly from the headliner, remove the bulb by turning it counterclockwise, and insert a new bulb by turning it clockwise to lock it into place. Reinstall the cargo light assembly in reverse.

Make sure that the headlight switch and the ignition switch are both turned off, then open the hood.