Lincoln F5AZ-2A635-A Cable Assembly - Parking

You can Select Your Vehicle to check if F5AZ-2A635-A fits your vehicle.

For the transverse cable, remove the cable adjusting nut first, followed by disconnecting the cable ends at the right rear of the transverse cable and the intermediate cable. Remove any retaining clips or brackets, take out the cable, reinstall the retaining clips or brackets holding the cable to the body, reconnect the cable ends, and reinstall the adjusting nut.

To replace the front cable, raise and support the vehicle on jackstands, release the parking brake, and loosen the adjusting nut at the adjuster. Disconnect the cable from the adjuster bracket and remove the retaining clip from the body. From inside the vehicle, disconnect the cable from the pedal assembly and remove it through the floorpan. To install, insert the cable through the floorpan holes and attach it to the control assembly inside the vehicle, ensuring the grommet is properly seated. Underneath the vehicle, fasten the cable to the adjuster bracket.

To replace the front cable on 1988 and 1989 models, raise the vehicle and support it on jackstands. Release the parking brake, loosen the adjusting nut at the adjuster, disconnect the cable from the adjuster bracket, remove the clip retaining the cable to the body, disconnect the cable from the pedal assembly inside the vehicle, and finally, remove the cable down through the floorpan.