Lincoln 9T4Z-1104-A Hub Assembly - Wheel

You can Select Your Vehicle to check if 9T4Z-1104-A fits your vehicle.

To disassemble all-wheel-drive models of 2010 vintage and below, find the ride height and remove the required parts. For 2010 or older, take out the tire, brake caliper, brake disc, brake hose bracket, drive axle/hub nut(s), and wheel speed sensor. For front-wheel drive automobiles, remove the wheel speed sensor and brake hose bracket. Consequently, take off bolts that hold the wheel bearing and hub assembly. In addition to that, for models such as 2011 and above mentioned version remove its wheel bearing together with hub assembly bolts then push the drive axle from the hub. Finally, for the 2010 or less models install your wheel hub/bearing assembly then insert your drive axle before tightening it up with bolts and nuts.

After installation, install the wheels, lower the vehicle, and tighten the wheel lug nuts to the torque specified in the Specifications.

For 2011 and later models, install the wheel hub/bearing assembly onto the rear knuckle, guiding the drive axle into the splines for all-wheel drive models. Tighten the hub assembly-to-rear knuckle bolts to the specified torque. The remainder of the installation is the reverse of the removal process. Tighten brake fasteners, and for all-wheel-drive models, tighten the drive axle/hub nut(s). Install the wheel and lug nuts, lower the vehicle, and torque the lug nuts.

To install the hub and bearing assembly, follow the reverse steps of removal. Additionally, make sure to replace all suspension fasteners that were removed with new ones and tighten them to the specified values listed in the Specifications.