Lincoln HU2Z-11V002-DSRM Starter Motor Assembly

You can Select Your Vehicle to check if HU2Z-11V002-DSRM fits your vehicle.

The cost of repairs should be checked to determine if it is more economical to obtain a new or exchange starter.

Apply the parking brake, then jack up the front of the vehicle and support it on axle stands.

Remove the under vehicle splash shield. Lift the engine cover off the ballstuds and remove it. Remove the battery and battery tray. Remove the shift cable and bracket. Place a drain pan under the engine oil filter and remove the filter. Remove the oil cooler mounting bolt and lower the cooler. Remove the battery cable ground wire nut and cable from the starter mounting stud bolt. Finally, pull back the protective cover from the starter's terminals, remove the nuts, and disconnect the battery cable and the electrical connector from the starter.

The steps to remove the starter motor in four-cylinder models are as follows: 1. Detach the battery cable from the negative terminal. 2. Raise and securely support the vehicle on jackstands. 3. Remove the underbody cover. 4. Disconnect the starter motor solenoid wire nut and starter motor battery cable nut. 5. Disconnect both wires from the starter. 6. Disconnect the ground wire from the starter mounting stud. 7. Remove the mounting stud bolts to take out the starter.

Remove the nut that secures the ground wire to the starter mounting stud and disconnect the ground wire from the stud. Remove the mounting stud bolts and remove the starter.

In V6 models, additional steps are involved in removing the starter motor. 1. Remove the air filter housing and the left-hand air filter housing outlet pipe for 2.7L engines. 2. On 3.5L and 3.7L engines, disconnect the transaxle shift cable. 3. Remove the transaxle shift lever nut and lever. 4. Remove the starter motor solenoid wire nut and starter motor battery cable nut. 5. Remove both wires from the starter motor. 6. Remove the starter motor mounting fasteners. 7. Take out the starter motor.