Lincoln 6W7Z-18124-C Shock Absorber Assembly

You can Select Your Vehicle to check if 6W7Z-18124-C fits your vehicle.

During installation, ensure all air is expelled from a new shock absorber (for 2002 and earlier models), install all bushings and grommets in the order of removal, and use 5116-18 locknuts on the self-tapping bolts if the threads in the lower control arm are stripped or damaged. Tighten all fasteners to the specified torque, with locknuts torqued to the same specification as the bolts.

Have an assistant grasp the lower edge of the tire and move the wheel in and out while you look for movement at the steering knuckle-to-control arm ball joint. If any movement is detected, the suspension ball joint(s) must be replaced.

Ensure that all air is expelled from the new shock absorber by extending and compressing it several times before placing the inner washer and rubber insulator on the shock piston rod. Insert the rod through the upper mounting hole in the frame, attach the outer insulator, washer, and a new stud retaining nut on the upper side of the frame, making sure the insulator "pilots" engage properly in the frame attaching holes. Tighten the nut to the specified torque.

Check the shock absorbers to ensure they are securely mounted and undamaged. Inspect the upper mounts for damage and wear. If damage or wear is observed, replace the shock absorbers as a set (front or rear).

Lower the vehicle by removing the jackstands.

For 2003 and later models, remove the three shock absorber upper mounting nuts, the brake caliper, and the brake disc. Additionally, remove the upper and lower stabilizer bar links. Remove the upper balljoint nut and separate the control arm from the steering knuckle. Finally, remove the lower mounting bolt and the shock absorber/coil spring assembly from the front end of the vehicle.