Lincoln YW3Z-13K359-AA Switch Assembly - Direction Indicator

You can Select Your Vehicle to check if YW3Z-13K359-AA fits your vehicle.

Disconnect the cable from the negative battery terminal. For 1989 and earlier models, grasp the switch lever securely and remove it by pulling straight out. Remove the steering column covers. Remove the switch cover, then disconnect the connector, remove the retaining screws and withdraw the Turn Signal Switch assembly from the steering column. Place the switch in position and install the screws, then connect the electrical connector. Install the steering column covers. Line up the tangs on the lever with the slot in the switch and install it by pushing straight in. For 1990 and later models, remove the steering column covers. On most models, the ignition lock cylinder must be removed first, and on models with tilt-column steering, the tilt lever must also be removed before removing the covers. Remove the two retaining screws, pull the switch out, disconnect the connector and detach the Turn Signal Switch assembly from the steering column. Connect the electrical connector, insert the switch into the steering column and install the screws. Install the steering column covers, lock cylinder and tilt lever if equipped. For all models, connect the cable to the negative battery terminal.

The hazard and turn signal switches and wires are integral parts of one assembly mounted in the steering column hub.

Line up the tangs on the lever with the slot in the switch and install it by pushing straight in.

Plug in the electrical connector, insert the switch into the steering column, and install the screws.