Mercury 6W1Z-3085-B Arm Assembly - Front Suspension

You can Select Your Vehicle to check if 6W1Z-3085-B fits your vehicle.

To remove the lower control arm, loosen lug nuts, raise vehicle, support with jackstands, remove wheel. Remove shock absorber or shock absorber/coil spring assembly. Disconnect stabilizer bar link (1988-1991 models). Remove coil spring (2002 and earlier models). Remove cotter pin and loosen castle nut on balljoint stud. Tap steering knuckle to release pressure and loosen stud. Remove balljoint stud nut and lower control arm by removing mounting bolts. Inspect bushings for damage; replace if necessary. Install lower control arm with mounting bolts (not fully tightened), use spring compressor (2002 and earlier models) and seat spring properly. Insert balljoint stud into steering knuckle, tighten castle nut, and install new cotter pin. Install shock absorber/coil spring assembly (2003 and later models). Attach stabilizer bar (1988-1991 models). Raise control arm to normal ride height, tighten pivot bolt nuts, install wheel, remove jackstands, lower vehicle, and tighten lug nuts.

Start by loosening the wheel lug nuts. Raise the vehicle and securely support it with jackstands. Remove the wheel.

Start by removing the shock absorber/coil spring assembly and harness retainers from the upper control arm. Remove the upper control arm mounting bolts.

Remove the shock absorber (for 2002 and earlier models). On 1988 through 1991 models, disconnect the stabilizer bar link from the lower control arm. Remove the coil spring (for 2002 and earlier models).

YES IT DOES INCLUDE THOSE PARTS