Mercury F5DZ-13466-B Bulb

You can Select Your Vehicle to check if F5DZ-13466-B fits your vehicle.

Remove the screw from the front direction indicator unit, withdraw the light unit from the bumper, rotate the bulb holder counterclockwise, and twist the bulb counterclockwise to remove it. Install the new bulb in reverse order.

Carefully pull the bulb straight out of the socket without rotating it.

Do not touch the bulb glass with your bare fingers.

Install the bulb holder in the headlight assembly.

Reach behind the headlight assembly and unplug the electrical connector, using a screwdriver to hold the clip out of the way.

Make sure that the headlight switch and the ignition switch are both turned off, then open the hood. Disconnect the wiring from the headlight bulb. Twist the bulb counterclockwise, then remove it.

Remove the assembly by pulling it to the rear, disengaging the locator pins, and then rotate the bulb socket counterclockwise to remove it. Replace the bulb by pulling it straight out and pushing the new one in. Reassemble the assembly.

Without touching the glass part of the new bulb with your bare fingers, insert the bulb into the headlight assembly. Make sure that the three metal tabs on the bulb are aligned with the three grooves of the plastic base, then push the bulb into the headlight assembly until the bulb's metal base is fully seated against the plastic base.

Without touching the glass with your bare fingers, insert the new bulb into the socket and then into the headlight housing. Install and tighten the retaining ring by turning it clockwise.

Slide the side light housing rearward, pull it out, disconnect the wiring, and reinstall it in reverse.

Without touching the glass with bare fingers, insert the bulb into the socket. Position the flat on the plastic base up.

Rotate the headlight bulb retaining ring counterclockwise and pull out the bulb socket. To remove the headlight bulb from the headlight housing, turn it counterclockwise and pull it out. On 2011 and later models, remove the headlight bulb by twisting it a small amount counterclockwise. Remove the park/turn bulb and the side marker light in the same manner.

Remove the headlight housing assembly. Rotate the retaining ring about 1/8-turn counterclockwise (viewed from the rear) and slide it off the base.

1. Remove the two taillight housing retaining screws. 2. To remove the taillight assembly from the vehicle, pull it out straight to the rear to disengage the two locator pins from their corresponding grommets in the rear fender. 3. Disconnect the electrical connectors from the two sockets in the taillight housing and remove the housing. 4. The upper bulb is the brake/taillight/turn signal bulb, and the lower bulb is the back-up light bulb.