Mercury F3VY-2V120-ARM Brake Caliper Assembly-Less Pads

You can Select Your Vehicle to check if F3VY-2V120-ARM fits your vehicle.

To overhaul the front calipers and 1989 and later Town Car rear calipers, start by raising the vehicle, supporting it on jackstands, and removing the wheels. Disconnect the brake hose banjo bolt and detach the hose from the caliper, ensuring no air enters the hydraulic control unit on ABS-equipped models. Clean the caliper exterior with brake system cleaner and place it on a clean workbench. Use compressed air with caution to remove the piston from the caliper and proceed to remove the dust boot and piston seal. Inspect the piston and caliper bore for damage, corrosion, or wear. Clean all parts with brake system cleaner and reassemble with new seals, bolt insulators, and caliper bolts if necessary. Lubricate with brake fluid and install the piston, dust boot, and caliper bolt insulators. Finally, follow the caliper installation procedure, connect the brake hose, bleed the brakes, and test the brake operation before placing the vehicle into normal service.

When proceeding with the rebuild, it's crucial to ensure that a rebuild kit is available. It's also essential to always rebuild calipers in pairs, never singly.

Inspect the dust boot and piston seal for damage, examine the caliper bore for imperfections and corrosion, check the caliper bolts, and clean all components with brake system cleaner.