Mercury F87Z-7822404-BAD Handle Assy - Door - Outer

You can Select Your Vehicle to check if F87Z-7822404-BAD fits your vehicle.

To begin the process of treating with the door trim panel and water shield, use the screws to unlatch the inner door handle assembly from the door. Subsequently, remove the handle link from the handle and the lock cylinder. For models from year 2001 onwards, the front door glass run channel bolt near the lower rear of the door has to be dozed and the glass guide fastener has to be loosened for the adjustment of the door glass. Get rid of the rods in the latch, then take out the latch screws and sliding away the latch assembly through the use of the Torx screws which holds it firmly to the door. For installation, it is done in the reversal of the process of removal and in the process, make sure that the rod retaining clips will be installed if a new latch is being put. Well push the control rod and place the lock cylinder rod on the latch then screwed to fasten it, examine the handle and lock before fixing the water shield and door panel back.

Remove the door trim panel and pull away the watershield. Note: The window glass must be in the full-raised position.

Drill out both rivets that secure the handle to the door and remove the handle.

Remove the screws securing the inner door handle assembly to the door (see illustration).