Mercury 8G1Z-18124-LB Shock Absorber Assy - Front

You can Select Your Vehicle to check if 8G1Z-18124-LB fits your vehicle.

In the engine compartment, mark the relationship of one of the mounting studs to the body, then loosen the four upper mounting nuts. Loosen the wheel lug nuts, raise the vehicle, and support it securely on jackstands. Remove the wheel. Detach the ABS wheel speed sensor harness from the strut. Support the outer end of the lower control arm with a floor jack. Unscrew the nuts securing the strut to the steering knuckle, then tap the bolts out with a hammer. Use the floor jack to lower the knuckle to allow room to remove the shock absorber/coil spring assembly, but be careful not to overextend the inner CV joint.

As part of a comprehensive steering and suspension check, examine tire wear patterns and inflation.

For these models, start by measuring the distance from the center of the wheel hub to the lip of the fender with the vehicle at rest. Then, open the trunk and pull back the interior quarter trim panel. Loosen the wheel lug nuts, raise the vehicle, and support it securely on jackstands, blocking the front wheels to prevent rolling. Remove the rear wheel and support the lower suspension arm with a floor jack.

Inspect the shock body for leaking fluid, dents, cracks, and other damage which would warrant replacement. Check the coil spring for chips or cracks in the spring coating and the spring seat for cuts, hardness, and general deterioration. If any undesirable conditions exist, proceed to the shock absorber/coil spring disassembly procedure.