Mercury 8L8Z-18125-C Shock Absorber Assembly

You can Select Your Vehicle to check if 8L8Z-18125-C fits your vehicle.

Unscrew the shock absorber lower mounting nut, then pull the shock off the mounting pin.

To remove the strut assembly, follow these steps: Support the strut and spring assembly with one hand. Remove the four struts to body nuts. Remove the assembly from the fender well.

To disassemble the strut assembly, follow these steps: Clean the strut from external dirt. Mount the strut in a vise. Install coil spring compressor tools, ensuring they are fully engaged. Compress the spring until all tension is relieved from the upper mount. Hold the strut piston rod with an Allen key and unscrew the thrust bearing retaining nut with a box-end wrench. Withdraw the top mounting, thrust bearing, upper spring seat, spring, boot, and bump stop.

The struts themselves cannot be serviced and should be replaced if they are faulty. However, the springs and related components can be replaced individually.

Tighten the mounting fasteners to the torque.

Before removing the strut, the following components should be disconnected: Brake hose bracket from the strut. Speed sensor wiring harness from the strut (if equipped with ABS). Stabilizer bar link from the strut bracket. Brake jounce hose clip (on later models) to move the hose out of the way.