Mercury 9L8Z-18124-AR Shock Absorber Assembly

You can Select Your Vehicle to check if 9L8Z-18124-AR fits your vehicle.

The initial steps include: Loosening the wheel lug nuts. Raising the vehicle securely on jackstands. Removing the wheel. These steps are necessary to create a safe working environment and provide access to the strut assembly.

Support it with a floor jack.

During reassembly of the strut assembly, consider the following key points: Install the coil springs with the paint mark at the bottom. Ensure that the coil spring ends are correctly located in the upper and lower seats before releasing the compressor. Verify that the bearing is correctly installed on the piston rod seat. Tighten the thrust bearing retaining nut to the specified torque.

If a new spring is to be installed, the original spring must be carefully released from the compressor.

Follow the reverse of the removal procedure.

When inspecting the strut assembly, check for the following: Strut body for leaking fluid, dents, cracks, or other damage. Coil spring for chips or cracks in the spring coating. Spring seat for cuts, hardness, and general deterioration. If any of these undesirable conditions exist, further inspection or replacement may be necessary.