Mercury 3W1Z-5310-HA Spring - Front

You can Select Your Vehicle to check if 3W1Z-5310-HA fits your vehicle.

Loosen the wheel lug nuts. Raise the vehicle and securely support it on jackstands. Remove the wheels. On 1988 through 1991 models, disconnect the stabilizer bar from the link. Remove the shock absorber. Disconnect the center link from the Pitman arm. Use a suitable spring compressor, following the manufacturer's instructions, to relieve tension on the spring. Compress the spring. Remove the nuts and bolts securing the inner end of the lower control arm to the frame. Slowly lower the control arm. Remove the spring and compressor as a unit. Note the installation of the upper insulator between the upper end of the spring and the frame. If the spring is to be replaced, slowly loosen the spring compressor tool until all tension is removed, then remove the tool.

Raise the axle assembly with the floor jack and insert the studs on the lower ends of the shocks into their holes in the brackets on the axle tubes. Install the stud retaining nuts, but don't fully tighten them yet.

This procedure specifically applies to 2002 and earlier models. Coil spring removal and installation on 2003 and later models are combined with shock absorber replacement.

Snap the right parking brake cable into the upper suspension arm retainer. Install the rear stabilizer bar. Connect the height sensor connector link to the upper control arm.