What are the instructions for replacing the MAF sensor and air filter in a Ford Expedition?

The MAF sensor is attached to the air filter housing. Do not stretch or bend the wiring to the MAF sensor while replacing the sensor. The air filter is located inside a housing at the left (driver's) side of the engine compartment. To remove the air filter, release the clamp that secures the two halves of the air cleaner housing together, then separate the cover halves and remove the air filter element. On 2007 and later Expedition/Navigator models, reach under the connector and pull back the retaining clip, then disconnect the connector before pulling up the air filter housing. Inspect the outer surface of the filter element. If it is dirty, replace it. If it is only moderately dusty, it can be reused by blowing it clean from the back to the front surface with compressed air. Because it is a pleated paper type filter, it cannot be washed or oiled. If it cannot be cleaned satisfactorily with compressed air, discard and replace it. While the cover is off, be careful not to drop anything down into the housing. Never drive the vehicle with the air cleaner removed. Excessive engine wear could result and backfiring could even cause a fire under the hood. Wipe out the inside of the air cleaner housing. Place the new filter into the air cleaner housing, making sure it seats properly. Installation of the housing is the reverse of removal.

Genuine Ford Expedition Air Filter

Air Cleaner

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

3 Air Filters found

View related parts
Ford Expedition Air Cleaner Element Assembly
Part Number: 7C3Z-9601-A
$14.37 MSRP: $27.49
You Save: $13.12 (48%)
ADD TO CART
Product Specifications
- Other Name: Element Assembly - Air Cleaner; Air Filter, Element
- Manufacturer Note: Service Part May Differ From Production
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2007-2024 Ford Expedition | 6 Cyl 3.5 L FLEX, 6 Cyl 3.5 L GAS, 6 Cyl 3.5L GTDI, 8 Cyl 5.4L | 10-Speed Automatic Transmission (10R80), 4-Speed Automatic Transmission 4R70W (AODE), 4-Speed Automatic Transmission 4R75E Livonia, 4-Speed Automatic Transmission AODEW/4R75E W/TSS, 4AT 4R75W, 6-Speed Automatic Transmission (6R75), 6-Speed Automatic Transmission (6R80), Four-Wheel Drive (Part Time) (Left Hand Drive), Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Expedition Air Cleaner Element Assembly
Part Number: F5OZ-9601-BA
$14.37 MSRP: $27.49
You Save: $13.12 (48%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Other Name: Element Assembly - Air Cleaner; Air Filter, Element, Filter
- Replaces: YC3Z-9601-AA, F6ZZ-9601-A, FA-1697
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1997-2004 Ford Expedition | 8 Cyl 4.6L, 8 Cyl 4.6L Romeo SOHC EFI, 8 Cyl 5.4L, 8 Cyl 5.4L Modular SOHC | 4AT 4R100, 4AT 4R70W, 4AT 4R75W, 4AT E4OD, 4-Speed Automatic Transmission 4R70W (AODE), 4-Speed Automatic Transmission 4R75E Livonia, 4-Speed Automatic Transmission AODEW/4R75E W/TSS, 6-Speed Automatic Transmission (6R75), 6-Speed Automatic Transmission (6R80), Four-Wheel Drive (Part Time) (Left Hand Drive), Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Ford Expedition Element Assy - Air Cleaner
Part Number: 4L3Z-9601-BA
$17.24 MSRP: $27.49
You Save: $10.25 (38%)
Ships in 1 Business Day
ADD TO CART
Product Specifications
- Other Name: Air Filter, Element
- Manufacturer Note: 3 Valve engine
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2005-2006 Ford Expedition | 8 Cyl 5.4L | 4AT 4R75W, 4-Speed Automatic Transmission 4R70W (AODE), 4-Speed Automatic Transmission 4R75E Livonia, 4-Speed Automatic Transmission AODEW/4R75E W/TSS, 6-Speed Automatic Transmission (6R75), 6-Speed Automatic Transmission (6R80), Four-Wheel Drive (Part Time) (Left Hand Drive), Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)

Ford Expedition Air Filter

Air Filter is premierowed with the responsibility of safeguarding the Ford Expedition's engine since it is responsible for trapping dirt and debris within it. Depend on the buildup of particles the filter obstructs air flow reducing performance and fuel efficiency. For the replacement air filters, Ford provides paper models or cotton gauze with the filtration and the flow rate being finely tuned. The paper is used for the filters traditionally, but the cotton gauze filters will give you more air and longer service. FOAM, OILED COTTON GAUZE and STAINLESS STEEL MESH type of Air filters are used according to the type of engine built into the car and type of driving cycle the vehicle will be exposed to. The air filter should then be inspected and replaced frequently so as to maintain the engine in good condition as well as its performance.

We provide a wide range of Ford Expedition Air Filter at the best prices possible. If you need Ford Expedition Air Filter, you can shop with confidence on our website. All our OEM parts come with a manufacturer's warranty and are delivered to your door step with a fast delivery service.

Ford Expedition Air Filter Parts Questions & Experts Answers

Element Assy - Air Cleaner
4L3Z-9601-BA
Q: What are the instructions for replacing the MAF sensor and air filter in a Ford Expedition?
A: The MAF sensor is attached to the air filter housing. Do not stretch or bend the wiring to the MAF sensor while replacing the sensor. The air filter is located inside a housing at the left (driver's) side of the engine compartment. To remove the air filter, release the clamp that secures the two halves of the air cleaner housing together, then separate the cover halves and remove the air filter element. On 2007 and later Expedition/Navigator models, reach under the connector and pull back the retaining clip, then disconnect the connector before pulling up the air filter housing. Inspect the outer surface of the filter element. If it is dirty, replace it. If it is only moderately dusty, it can be reused by blowing it clean from the back to the front surface with compressed air. Because it is a pleated paper type filter, it cannot be washed or oiled. If it cannot be cleaned satisfactorily with compressed air, discard and replace it. While the cover is off, be careful not to drop anything down into the housing. Never drive the vehicle with the air cleaner removed. Excessive engine wear could result and backfiring could even cause a fire under the hood. Wipe out the inside of the air cleaner housing. Place the new filter into the air cleaner housing, making sure it seats properly. Installation of the housing is the reverse of removal.