Manufacturer Note: New Gasket Must Be Installed When Changing Pump. (Gasket Not Included With Pump)
Replaced by: 7S7Z-8501-C
Warranty: This genuine part is guaranteed by Ford's
factory warranty.
Fits the following Vehicles:
2013-2015 Ford Fusion | 4 Cyl 1.6L PI TC ETHNL | 6-Speed Automatic Transmission 6F Mid-Range, 6-Speed Automatic Transmission 6F55, 6-Speed Manual Transmission - B6, ECVT Auto Trans Power Split, Four-Wheel Drive (Full Time) (Left Hand Drive), Front-Wheel Drive (Left Hand Drive), Left Hand Drive
A: Start by disconnecting the negative battery cable and draining the cooling system to remove the water pump. Depending on the engine type, you may need to loosen the water pump pulley bolts or remove the drive belt. Remove necessary components such as the wheel, fender splash shield, air filter housing, turbocharger inlet pipe, drive belt tensioner, and timing belt, and disconnect the electric connector for the water pump clutch. Take out the pump by removing the water pump mounting bolts. Clean gasket and O-ring surfaces present on both of them as well as on housing and get rid of any debris. To fix a new gasket in place use RTV sealant and coat O-rings with clean coolant. Once you have installed the new water pump, tighten the bolts and follow the remaining steps in reverse order. Run the engine to see if there are any leaks.