How can driveaxle oil seals be replaced on Ford Taurus?

Oil leaks frequently occur due to wear of the wheel seals, and replacement of these seals is relatively easy since the repair can be performed without removing the transaxle from the vehicle. Wheel seals are located at the sides of the transaxle, where the driveaxles are attached. If leakage at the seal is suspected, raise the vehicle and support it securely on jackstands; lubricant will be found on the sides of the transaxle, below the seals if the seal is leaking. Remove the driveaxles, then use a screwdriver or prybar to carefully pry the seal out of the transaxle bore. If the seal cannot be removed with these tools, a special seal removal tool, available at auto parts stores, will be required. To install the new seal, use a large section of pipe or a large deep socket, slightly smaller than the outside diameter of the seal, as a drift. Drive it into the bore squarely and ensure it's completely seated, coating the seal lip with transaxle lubricant. Finally, install the driveaxle(s), taking care not to damage the lip of the new seal with the inboard splines of the driveaxle.

Genuine Ford Taurus Wheel Seal

Wheel Axle Seal

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

3 Wheel Seals found

View related parts
Ford Taurus Seal
Part Number: 5L8Z-4B416-AA
$12.48 MSRP: $17.78
You Save: $5.30 (30%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Manufacturer Note: 58mm
- Position: Driver Side
- Replaces: F57Z-3254-BA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2008-2019 Ford Taurus | 4 Cyl 2.0L EcoBoost (240PS) , 6 Cyl 3.5L Cyclone Petrol TIVCT, 6 Cyl 3.5L DOHC T/C, 6 Cyl 3.5L DOHC VCT SMPI, 6 Cyl 3.7L DOHC | 6-Speed Automatic Transaxle - AWF21, 6-Speed Automatic Transmission 6F Mid-Range, 6-Speed Automatic Transmission 6F50, 6-Speed Automatic Transmission 6F55, CVT Select Shift Transmission, Four-Wheel Drive (Full Time) (Left Hand Drive), Four-Wheel Drive (Part Time) (Left Hand Drive), Front-Wheel Drive (Left Hand Drive), Left Hand Drive
View related parts
Ford Taurus Seal
Part Number: E6DZ-1249-A
$13.73 MSRP: $18.75
You Save: $5.02 (27%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1986-1989 Ford Taurus | 4 Cyl 2.5L, 6 Cyl 3.0L, 6 Cyl 3.8L | 3AT ATX, 4AT AXOD, 5MT
View related parts
Ford Taurus Seal
Part Number: E9SZ-2217-A
Product Specifications
- Other Name: Grease Seal, Oil Seal
- Manufacturer Note: Cobra IRS
- Position: Front
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1986-2007 Ford Taurus | 4 Cyl 2.5L, 6 Cyl 3.0L, 6 Cyl 3.2L, 6 Cyl 3.8L, 8 Cyl 3.4L | 3AT ATX, 4AT 4F50N, 4AT AX4N, 4AT AX4S, 4AT AXOD, 4AT AXOD-E, 5MT

Ford Taurus Wheel Seal

The Wheel Seal on the Ford Taurus automobiles plays the important function of protecting the wheel bearing and hub to adverse conditions such as the contaminants like dirt, debris and rocks. Its main role is therefore to eliminate any loss of lubricant as well as to seal off the contaminants that may harm the wheel bearing assembly. It is also rendered that correct lubrication is required to prevent seizing, overheating of the seals and their consequent brittleness. Within the Ford Taurus there are front and rear inner and outer types of Wheel Seals that have been used in the past. It is important to emphasize that these seals applied as the complete kits and are produced by the famous manufacturers: Motorcraft and Timken. The only differences between these Wheel Seals are in their style and application which allows the Wheel Seal to fit various Taurus models while adhering to the same great quality.

We provide a wide range of Ford Taurus Wheel Seal at the best prices possible. If you need Ford Taurus Wheel Seal, you can shop with confidence on our website. All our OEM parts come with a manufacturer's warranty and are delivered to your door step with a fast delivery service.

Ford Taurus Wheel Seal Parts Questions & Experts Answers

Seal
5L8Z-4B416-AA
Q: How can driveaxle oil seals be replaced on Ford Taurus?
A: Oil leaks frequently occur due to wear of the wheel seals, and replacement of these seals is relatively easy since the repair can be performed without removing the transaxle from the vehicle. Wheel seals are located at the sides of the transaxle, where the driveaxles are attached. If leakage at the seal is suspected, raise the vehicle and support it securely on jackstands; lubricant will be found on the sides of the transaxle, below the seals if the seal is leaking. Remove the driveaxles, then use a screwdriver or prybar to carefully pry the seal out of the transaxle bore. If the seal cannot be removed with these tools, a special seal removal tool, available at auto parts stores, will be required. To install the new seal, use a large section of pipe or a large deep socket, slightly smaller than the outside diameter of the seal, as a drift. Drive it into the bore squarely and ensure it's completely seated, coating the seal lip with transaxle lubricant. Finally, install the driveaxle(s), taking care not to damage the lip of the new seal with the inboard splines of the driveaxle.