How do you remove the air spring on Lincoln Town Car?

To remove the air spring, start by turning off the air suspension switch and loosening the wheel lug nuts. Then, raise the rear of the vehicle and secure it on jackstands. Remove the wheel and heat shield. Take out the spring retainer clip and proceed to remove the air spring solenoid by unplugging the electrical connector and disconnecting the air line. Remove the solenoid clip and rotate the solenoid counterclockwise to the first stop, then pull it out to the second stop to release any residual air. After bleeding the air, rotate the solenoid counterclockwise to the third stop and remove it from the housing. To remove the spring, use an air spring removal tool or an equivalent tool to pry it off the axle tube and spring seat. For installation, position the spring between the frame seat and the axle and carefully push it into place. Install the air spring solenoid by applying a light coat of silicone dielectric grease to the O-rings and inserting it into the air spring end cap, rotating it clockwise to the third stop, then pushing it to the second stop, and finally rotating it to the first stop. Install the solenoid clip. Place the air spring into the frame seat, install the push-on spring retainer clip, and reconnect the air line and electrical connector. Install the heat shield. Align the lower end of the air spring piston with the axle seat, push down on the piston to snap it into the axle seat at rebound. Install the wheel and lug nuts, lower the vehicle, and partially inflate the air springs by turning on the air suspension switch and the ignition key. Finally, fully lower the vehicle and allow the springs to fully inflate before tightening the wheel lug nuts to the specified torque.

Genuine Lincoln Town Car Air Suspension

Air Ride

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

6 Air Suspensions found

View related parts
Lincoln Town Car Spring
Part Number: 3U2Z-5580-PA
$227.13 MSRP: $335.00
You Save: $107.87 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Air Spring
- Replaces: F8VZ-5560-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1998-2005 Lincoln Town Car | 8 Cyl 4.6L, 8 Cyl 4.6L Romeo SOHC EFI | 4-Speed Automatic Transmission 4R70W (AODE), 4-Speed Automatic Transmission 4R75E Livonia, 4-Speed Automatic Transmission AODEW/4R70E W/TSS, 4-Speed Automatic Transmission AODEW/4R70E W/TSS*S/V, 4-Speed Automatic Transmission AODEW/4R75E W/TSS S/V, 4-Speed Automatic Transmission NAAO AODEW/4R70W*S/VIL, 4AT 4R70W, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Lincoln Town Car Spring
Part Number: F8VZ-5560-AA
$227.13 MSRP: $335.00
You Save: $107.87 (33%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Replaced by: 3U2Z-5580-PA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 1998-2003 Lincoln Town Car | 8 Cyl 4.6L | 4AT 4R70W
View related parts
Lincoln Town Car Spring
Part Number: 6W1Z-5560-AA
Product Specifications
- Other Name: Air Spring
- Manufacturer Note: Air-ride suspension, with the solenoid
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2006-2011 Lincoln Town Car | 8 Cyl 4.6L Romeo SOHC EFI | 4-Speed Automatic Transmission 4R70W (AODE), 4-Speed Automatic Transmission 4R75E Livonia, 4-Speed Automatic Transmission AODEW/4R70E W/TSS, 4-Speed Automatic Transmission AODEW/4R70E W/TSS*S/V, 4-Speed Automatic Transmission AODEW/4R75E W/TSS S/V, 4-Speed Automatic Transmission NAAO AODEW/4R70W*S/VIL, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Lincoln Town Car Spring
Part Number: 3U2Z-5580-AA
Product Specifications
- Other Name: Air Spring, Coil Spring
- Replaces: F5AZ-5560-BB, F5AZ-5560-B
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2000-2005 Lincoln Town Car | 8 Cyl 4.6L, 8 Cyl 4.6L Romeo SOHC EFI | 4-Speed Automatic Transmission 4R70W (AODE), 4-Speed Automatic Transmission 4R75E Livonia, 4-Speed Automatic Transmission AODEW/4R70E W/TSS, 4-Speed Automatic Transmission AODEW/4R70E W/TSS*S/V, 4-Speed Automatic Transmission AODEW/4R75E W/TSS S/V, 4-Speed Automatic Transmission NAAO AODEW/4R70W*S/VIL, 4AT 4R70W, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Lincoln Town Car Spring
Part Number: 6W1Z-5560-BA
Product Specifications
- Other Name: Air Spring
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2006-2011 Lincoln Town Car | 8 Cyl 4.6L Romeo SOHC EFI | 4-Speed Automatic Transmission 4R70W (AODE), 4-Speed Automatic Transmission 4R75E Livonia, 4-Speed Automatic Transmission AODEW/4R70E W/TSS, 4-Speed Automatic Transmission AODEW/4R70E W/TSS*S/V, 4-Speed Automatic Transmission AODEW/4R75E W/TSS S/V, 4-Speed Automatic Transmission NAAO AODEW/4R70W*S/VIL, Left Hand Drive, Rear-Wheel Drive (Left Hand Drive)
View related parts
Lincoln Town Car Spring
Part Number: F5AZ-5560-BB
Product Specifications
- Replaced by: 3U2Z-5580-AA
- Warranty: This genuine part is guaranteed by Ford's factory warranty.
Fits the following Vehicles:
- 2000-2003 Lincoln Town Car | 8 Cyl 4.6L | 4AT 4R70W

Lincoln Town Car Air Suspension

Air Suspension is an equipment installed in Lincoln Town Car cars that seeks to improve the quality of the ride by having a feature called rubber air bag filled with compressed air. It allows for regulation of the pressure of air within the spring in particular region to be altered in order to suit the driver's taste in performance and comfort. Some of the styles of Air Suspension used in the Town Car models in the years have been; The above are some of the Air Spring that has been used in the town car models and has assisted in making it versatile. The major difference between these types boils down to the details of air pressure that remain under the vehicles' control, and that defines the ride. It enhances control and ride comfort on every surface making the air spring system exciting to use when unpaved roads are encountered in Lincoln Town Car Livery Services.

We provide a wide range of Lincoln Town Car Air Suspension at the best prices possible. If you need Lincoln Town Car Air Suspension, you can shop with confidence on our website. All our OEM parts come with a manufacturer's warranty and are delivered to your door step with a fast delivery service.

Lincoln Town Car Air Suspension Parts Questions & Experts Answers

Spring
3U2Z-5580-PA
Q: How do you remove the air spring on Lincoln Town Car?
A: To remove the air spring, start by turning off the air suspension switch and loosening the wheel lug nuts. Then, raise the rear of the vehicle and secure it on jackstands. Remove the wheel and heat shield. Take out the spring retainer clip and proceed to remove the air spring solenoid by unplugging the electrical connector and disconnecting the air line. Remove the solenoid clip and rotate the solenoid counterclockwise to the first stop, then pull it out to the second stop to release any residual air. After bleeding the air, rotate the solenoid counterclockwise to the third stop and remove it from the housing. To remove the spring, use an air spring removal tool or an equivalent tool to pry it off the axle tube and spring seat. For installation, position the spring between the frame seat and the axle and carefully push it into place. Install the air spring solenoid by applying a light coat of silicone dielectric grease to the O-rings and inserting it into the air spring end cap, rotating it clockwise to the third stop, then pushing it to the second stop, and finally rotating it to the first stop. Install the solenoid clip. Place the air spring into the frame seat, install the push-on spring retainer clip, and reconnect the air line and electrical connector. Install the heat shield. Align the lower end of the air spring piston with the axle seat, push down on the piston to snap it into the axle seat at rebound. Install the wheel and lug nuts, lower the vehicle, and partially inflate the air springs by turning on the air suspension switch and the ignition key. Finally, fully lower the vehicle and allow the springs to fully inflate before tightening the wheel lug nuts to the specified torque.