Ford 6E5Z-13466-AC Bulb

You can Select Your Vehicle to check if 6E5Z-13466-AC fits your vehicle.

For halogen headlights on all models except Montego, start by disconnecting the cable from the negative battery terminal. Next, remove the bulb access cover from the back of the headlight. Rotate the bulb holder counterclockwise to release the tabs and pull it out of the housing. Disconnect the electrical connector by raising the tab on it. Installation is the reverse of removal. For Montego models, remove the headlight housing by taking out the six screws and the headlight access cover. Then, rotate the bulb holder counterclockwise and remove it from the housing, followed by disconnecting the electrical connector. Again, installation is the reverse of removal.

To replace front turn signal bulbs, loosen wheel lug nuts, raise vehicle, remove wheel and inner fender splash shield. Turn signal bulb holder counterclockwise to remove, take out bulb. For high-mount brake light bulbs, remove assembly, disconnect connector, replace bulb. For brake/tail/turn/back-up light bulbs, remove assembly, rotate bulb socket counterclockwise, replace bulb. For license plate light bulbs, remove light assembly, turn socket counterclockwise, replace bulb. For side turn signal lamps, slide housing rearward, disconnect wiring, reinstall in reverse. For fog light bulbs, remove wheel, splash shield fasteners, disconnect wiring, remove bulb. For interior/map reading light bulbs, pry lens from assembly, replace bulb. For cargo light bulbs, pry assembly from headliner, remove bulb, insert new bulb, reinstall assembly.

Remove the four trunk lid trim panel nuts, then remove the trim panel from the trunk lid.

To access the low-beam bulb on the right headlight housing of a vehicle with ABS, remove the bulb access cover screw (Fender splash shield access cover for the right low-beam headlight bulb (2006 through 2009 models)) and remove the access cover from the fender splash shield.

Unscrew the retainer from the back of the headlight.

Test headlight operation, then close the hood.

Test the headlight operation, then close the hood.

Start by loosening the front wheel lug nuts, raising the front of the vehicle, and placing it on jackstands. Remove the left or right front wheel and then the inner fender splash shield. Locate the turn signal bulb holder, turn it counterclockwise to remove it, and take out the turn signal bulb. Installation is the reverse of removal.

Remove the rubber boot from the headlight assembly.

Disconnect the electrical connector from the back of the headlight (Unplug the electrical connector from the headlight).