Ford YR3Z-13466-AD Bulb

You can Select Your Vehicle to check if YR3Z-13466-AD fits your vehicle.

Install the new bulb using a reversal of the removal procedure and have the headlight beam alignment checked.

No, the light emitting diodes (LEDs) are an integral part of the housing and are not serviceable separately.

Have the headlight alignment checked and, if necessary, adjusted by a dealer service department or service station.

To access the left (driver's side) high-beam or low-beam bulb on four-cylinder and 3.0L V6 models, remove the air filter housing.

Remove the six screws and the headlight access cover.

Some models use High Intensity Discharge (HID) bulbs instead of conventional halogen bulbs. According to the manufacturer, the high voltages produced by this system can be fatal in the event of a shock. Also, the voltage can remain in the circuit even after the headlight switch has been turned to OFF and the ignition key has been removed.

Slide the retainer on and turn it clockwise until it hits the stop.

Disengage the headlight bulb retainer spring.

Pry or slide the light assembly from the liftgate, remove the bulb socket by turning it counterclockwise, and replace the bulb. Reassemble following the reverse of removal.

Pry or slide the light assembly from the liftgate, remove the bulb socket by turning it counterclockwise, and replace the bulb. Reassemble following the reverse of removal.

No, for your safety, it is recommended that you have this service performed by a dealer service department or other qualified repair shop.

Plug in the electrical connector.

1. Remove the two taillight housing retaining screws. 2. To remove the taillight assembly from the vehicle, pull it out straight to the rear to disengage the two locator pins from their corresponding grommets in the rear fender. 3. Disconnect the electrical connectors from the two sockets in the taillight housing and remove the housing. 4. The upper bulb is the brake/taillight/turn signal bulb, and the lower bulb is the back-up light bulb.

Rotate the headlight bulb retaining ring counterclockwise and pull out the bulb socket. To remove the headlight bulb from the headlight housing, turn it counterclockwise and pull it out. On 2011 and later models, remove the headlight bulb by twisting it a small amount counterclockwise. Remove the park/turn bulb and the side marker light in the same manner.

Align the socket locating tabs with the grooves in the forward part of the plastic base, then push the socket firmly into the base. Make sure the base mounting flange contacts the socket.