Ford F3AZ-6316-A Harmonic Balancer Pulley

You can Select Your Vehicle to check if F3AZ-6316-A fits your vehicle.

Go ahead and remove the shroud bolts of the fan, then put it over the fan. Remove the drivebelts, fan/clutch assembly, and shroud. If you are to remember only one thing about this process, it should be the mark on the vibration damper and crankshaft pulley. Then snatch off the pulley and front crankshaft bolt. Before yanking off these four pulley bolts, mark that pulley. Next, gently pull it away using a puller to separate it from the engine access hole. Once done with lubing its hub, set up this damper on its hooked position as placed on the crankshaft by gluing together a washer and bolt. Use a hammer instead if necessary to push through. Finally, your way back around to cooling system service steps before adding enough coolant for testing any possible leakages.

Don't use a puller with jaws that grip the outer edge of the damper. The puller must be the type shown in the illustration that utilizes bolts to apply force to the damper hub only.

The keyway in the damper must be aligned with the Woodruff key in the crankshaft nose.

Clean the crankshaft nose and the seal contact surface on the vibration damper.

It is important to mark the crankshaft pulley and vibration damper so they can be reassembled in the same relative position, as they are initially balanced as a unit.

Install the damper on the end of the crankshaft, ensuring the keyway in the damper is aligned with the Woodruff key in the crankshaft nose. If the damper cannot be seated by hand, slip the large washer over the bolt, install the bolt, and tighten it to pull the damper into place. Tighten the bolt to the specified torque.