Ford 1W1Z-13008-BA Headlamp Assembly

You can Select Your Vehicle to check if 1W1Z-13008-BA fits your vehicle.

The headlights must be aimed correctly to avoid accidents and ensure good visibility. They should be checked every 12 months and after any headlight replacement or front end body work. Adjusting screws control the up-and-down and left-and-right movement of the headlights. The simplest method for adjustment requires a blank wall, level floor, and masking tape. Position the tape vertically and horizontally in reference to the vehicle centerline and headlight centerlines. Adjust the low beam so the high intensity zone is two inches below and to the right of the horizontal line. Use the adjusting screws to raise, lower, move left, or move right. For the high beams, the high intensity zone should be vertically centered just below the horizontal line. If a compromise is necessary, prioritize the correct aim for the low beams. Get the headlights adjusted by a professional as soon as possible.

Remove the cover (if equipped) and reach behind the headlight assembly, grasp the bulb holder and turn it counterclockwise to remove it. Lift the holder assembly out for access to the bulb. On 1998 and later models, the headlight housing must be removed for access to the bulb holder.

Insert the housing into the grille opening and press it into place until it seats securely in the retainers.