Ford 5U2Z-18V125-W Kit - Shock Absorber

You can Select Your Vehicle to check if 5U2Z-18V125-W fits your vehicle.

During installation, ensure all air is expelled from a new shock absorber (for 2002 and earlier models), install all bushings and grommets in the order of removal, and use 5116-18 locknuts on the self-tapping bolts if the threads in the lower control arm are stripped or damaged. Tighten all fasteners to the specified torque, with locknuts torqued to the same specification as the bolts.

Allow the rear axle to hang freely until the shock absorbers finish venting through the compressor. Support the rear axle with a floor jack to prevent it from dropping when the shock absorbers are disconnected.

If the vehicle has an air suspension, turn the air suspension switch to On, start the engine, and let the compressor inflate the air suspension springs before driving.

Worn or damaged suspension and steering linkage components can result in excessive and abnormal tire wear, poor ride quality, vehicle handling issues, and reduced fuel economy.

Grasp each front tire at the front and rear edges, push in at the front, pull out at the rear, and feel for play in the steering system components.

Removal starts by removing the shock absorber upper attaching nut, washer, and bushing to detach the upper end of the shock absorber. For upper balljoint replacement on 1992 and later models, it's crucial to mark the location of the alignment marks on the adjustment cams before removing the two retaining nuts.