Ford 6R3Z-18125-MA Kit - Shock Absorber

You can Select Your Vehicle to check if 6R3Z-18125-MA fits your vehicle.

Mark the positions of the bolt heads.

To reassemble the strut assembly, the rubber bumper and dust cover should be installed. The coil spring should be placed onto the strut, ensuring correct positioning onto the lower spring seat. The upper bearing assembly should be installed, aligning the notch on the bearing assembly with the clevis on the bottom of the strut. The damper rod nut should be installed and tightened to the specified torque. Finally, the spring compressor tool can be removed, and the strut/spring assembly can be installed.

With the mounting fasteners in place, carefully raise the axle so that the mark on the shock lines up with the dust sleeve. Tighten the mounting fasteners to the torque specified in the vehicle's specifications.

To inspect ball joints, clean the lower end of the steering knuckle. Have an assistant grasp the lower edge of the tire and move the wheel in and out while you observe the steering knuckle-to-control arm ball joint for any movement. If there is any movement, it indicates that the suspension ball joint(s) need to be replaced.