Ford 8L1Z-18125-H Kit - Shock Absorber

You can Select Your Vehicle to check if 8L1Z-18125-H fits your vehicle.

You should first loosen the front wheel lug nuts, then raise the front of the vehicle and support it securely on jackstands. After applying the parking brake, remove the wheels. To remove the upper shock mounting nut, use an open-end wrench to hold the shock from turning while removing the nut.

Remove the parking brake cable bracket bolt, upper arm-to-wheel knuckle bolt, and upper arm bushing nuts and bolts.

Remove the nut and bolt.

If leakage is noted, replace the shocks as a set. However, a light film of fluid is no cause for concern.

Additional steps include loosening the front wheel lug nuts, raising the vehicle, removing the wheels, detaching various components like the tie-rod end, upper ball joint, and fasteners attaching the lower end of the shock absorber to the lower control arm. Finally, remove the shock absorber/coil spring assembly for inspection and replacement as needed. Installation follows the reverse of the removal process, ensuring proper tightening of fasteners and lug nuts.

Repeat the same check at each of the three remaining corners of the vehicle.

Remove the indicated bolts.

Yes, the importance of simulating ride height before final tightening is emphasized.