Ford 8G1Z-18124-C Shock Absorber Assembly - Front

You can Select Your Vehicle to check if 8G1Z-18124-C fits your vehicle.

Ensure the steering is unlocked. Loosen the strut upper mounting nuts but do not remove them. Loosen the wheel lug nuts, raise the vehicle and support it securely on jackstands, then remove the wheel. Have an assistant depress the brake pedal, then remove the driveaxle/hub nut. Remove the brake disc, separate the tie-rod end from the steering knuckle, and detach the stabilizer bar link from the strut. Detach the wheel speed sensor harness from the strut, remove the bolt, and pull the wheel speed sensor from the steering knuckle. Separate the control arm balljoint from the steering knuckle. Using a front wheel hub remover, press the driveaxle from the hub splines. Remove the upper mounting nuts and remove the strut and steering knuckle as an assembly.

If fluid leakage is found in the shock absorbers, they should be replaced.

For these models, start by measuring the distance from the center of the wheel hub to the lip of the fender with the vehicle at rest. Then, open the trunk and pull back the interior quarter trim panel. Loosen the wheel lug nuts, raise the vehicle, and support it securely on jackstands, blocking the front wheels to prevent rolling. Remove the rear wheel and support the lower suspension arm with a floor jack.

Inspect the shock body for leaking fluid, dents, cracks, and other damage which would warrant replacement. Check the coil spring for chips or cracks in the spring coating and the spring seat for cuts, hardness, and general deterioration. If any undesirable conditions exist, proceed to the shock absorber/coil spring disassembly procedure.