Ford 8G1Z-18125-E Shock Absorber Assembly

You can Select Your Vehicle to check if 8G1Z-18125-E fits your vehicle.

While an assistant turns the steering wheel, examine the steering components for free movement, chafing, and binding, identifying any areas of slack.

Inspect the shock body for leaking fluid, dents, cracks, and other damage which would warrant replacement. Check the coil spring for chips or cracks in the spring coating and the spring seat for cuts, hardness, and general deterioration. If any undesirable conditions exist, proceed to the shock absorber/coil spring disassembly procedure.

The inspection procedures are the same as for the 2012 and earlier models.

Remove the brake caliper and mounting bracket as an assembly, ensuring to support the caliper with a length of wire to avoid hanging by the brake hose. Proceed to remove the upper shock absorber mounting nut and index the spring position on the shock absorber and the upper spring isolator. Raise the floor jack slightly to compress the coil spring and remove the trailing arm-to-rear knuckle bolt. If it's an all-wheel drive model, loosen the trailing arm to subframe bolt, or if it's a front-wheel drive model, remove the trailing arm-to-subframe bolt and remove the arm. Continue by removing the lower arm-to-rear knuckle bolt, and if it's a front-wheel drive model, loosen the lower arm-to-subframe bolt. Slowly lower the floor jack and remove it, followed by removing the shock absorber lower mounting bolt and maneuvering the shock absorber and coil spring out from between the lower arm and the subframe.